1-17
(Model: I, J) (Model: G, H)
CRT C.B.A.
Clamper
Clamper
P354
Degaussing Coil Connector
TV Main
C.B.A.
Main C.B.A.
Deflection
Yoke
Connector
P1002
P4592
Flyback
Transformer
Clamper
Clamper
Clamper
Frame
Anode Cap
Deflection Yoke
Degaussing Coil
Grounding Wire
PK3
PK2
PK1
Clamper
45°
+
-
Red
White
Speaker-R
Clamper
Anode Lead:
DO NOT touch the Picture Tube.
Speaker Connector Leads:
DO NOT touch Power circuit on Main C.B.A.
P1002 Connector Leads:
DO NOT touch C805.
Deflection Yoke Connector Leads and CRT Leads:
DO NOT touch Heat Sink Plate.
CRT Leads
Anode Lead
Picture Tube
Hea t Sink
Plate
Deflection Yoke
Connector Leads
P1002
Connector
Leads
Speaker
Connector
Leads
C805
(Model : G, H, I, J)
•
•
•
•
After servicing, make sure that all wires, leads, and clampers
are placed in their original position. It is important for the best
operation of the unit.
Note:
No lead wires or flat cables should touch any heating parts
or the Heat Sink Plate.
Use extreme care especially for followings.
Power circuit
on Main C.B.A.
Fig. 8-2
To Next Page
Loading...
