5.1.1.1. Notes in chart
1. Installation of Top Panel
Install the Top Panel front portion at a downward angle so
that the tab on the Front Panel Ass’y fits into the hole in the
Top Panel.
Then, lower the rear portion into place and tighten 4 Screws
(501, 502).
2. Installation of Front Panel Ass’y
CAUTION:
Opener Lever may be damaged when Front Panel
Ass’y is installed, with Cassette Door-Lid of Front
Panel Ass’y and Opener Lever of Cassette Up Ass’y
set incorrectly.
a. When installing the Front Panel Ass’y, swing the
Cassette Door-Lid all the way open until the
Cassette Door tab clears the Opener Lever.
b. Make sure that all locking tabs are aligned properly.
Then, press the Front Panel straight in.
Fig. D3
3. Installation of Mechanism Chassis and Cassette Up
Ass’y onto Main C.B.A.
a. Make sure the Mode Select SW. on the Main C.B.A. is
in EJECT position. If not, rotate the Mode Select SW.
until the alignment projection is in the EJECT Position.
Fig. D4
b. Make sure the phase hole of the Main Cam Gear on the
bottom side of Mechanism Unit is in EJECT position.
Fig. D5
c. Install the Mechanism Chassis straight onto the Main
C.B.A. so that the Photo Transistor Unit (712) clears the
hole in the Mechanism Chassis and that 3 Connectors
(P5002, P4001, P6201) are aligned and seated
securely.
5.2. MECHANISM SECTION
Refer to the Service Manual for R4-Mechanism Chassis for PV-
Model (Order No. MKE0401000C1).
14
PV-V4525S / PV-V4535S-K / PV-455S-K
To Next Page
Loading...
