Panasonic PV-VS4821-K - Time Zone Adjust

17
Add or Delete a Channel
To add channel:
Select channel with number
keys and press ADD/DLT.
To delete channel:
Select channel with CH / or
number keys and press ADD/DLT.
C HANNEL 08 ADDED
C HANNEL 08 DE L E T ED
Time Zone Adjust
2) Press to select
“TIME ZONE ADJUST”
SELECT :
EXIT : ACTION
SET:
AUTO CLOCK SET
MANUAL
TIME ZONE ADJUST : 0
VCR C
/ A CLOCK CH
VCR’s Output
Channel
1) Press to select
“VCR’S OUTPUT CH.”
VCR C / A CLOCK CH
SELE C T : SET :
EXIT
: ACT I O N
REPEAT PLAY :OFF
T
I ME STAMP :ON
REMOTE WARNING :ON
AUTO SHUT
- OFF :ON
S
- VHS ET :OFF
IDIOMA/LANGUE : ENGLISH
VCR’ S OUTPUT CH :3
2) Press .
3) Press ACTION.
After 3 seconds
VCR C / A CLOCK CH
SELE C T : SET :
EXIT
: ACT I O N
REPEAT PLAY :OFF
T
I ME STAMP :ON
REMOTE WARNING :ON
AUTO SHUT
- OFF :ON
S
- VHS ET :OFF
IDIOMA/LANGUE : ENGLISH
VCR’ S OUTPUT CH :4
• To Make Corrections,
repeat steps 1) ~ 3).
DST (Daylight Saving Time)
VCR auto adjusts clock for DST.
(Page 11.)
Spring (First Sunday in April)
DST:ON --> Sets clock ahead one hour.
Autumn (Last Sunday in October)
DST:ON --> Turns clock back one
hour.
• If your area does not observe
Daylight Saving Time, select
DST:OFF.
• Keep these time changes in mind
when programming the VCR for
timer recordings.
IF YOU PRESS ACTION
KEY, VCR ’ S OUTPUT CH
SWITCHES TO CH 4.
VCR C / A CLOCK CH
PLEASE TUNE YOUR TV TO
CH 4.
VCR C / A CLOCK CH
1) Press to select
“CLOCK.”
and press or to
subtract or add hour(s)
as necessary.
AUTO CLOCK SET
MANUAL
TIME ZONE ADJUST : 0
SELE
C T :
EXIT
: ACT I O N
VCR C / A CLOCK CH
ADD/DLT
NUMBER
keys
VCR
CH /
*Important: If a remote control button does not
work when pressed, press the VCR
button on the remote and try the
button again.
(Only when Auto Clock is set.)
ck VCR’s Output Channel
Basic
Operation
POWER
:PLAY
:STOP
:REW
:FF
SELECT/
SET
ACTION
3) Press ACTION.
4) Press POWER off and
wait a maximum
10 minutes until
AUTO CLOCK SET is
performed by the VCR.
•“TIME ZONE ADJUST”
returns to “0”
if clock is set manually.