Panasonic Ramsa WR-S4412 - IN;OUT CABLE INFORMATIONS; XLR Type Connectors; 1;4 Tip-sleeve Phone Plug (Input and Output); 1;4 Tip-ring-sleeve Phone Plug

IN/OUT CABLE INFORMATIONS
1.
XLR
Type
Connectors
3.
1/4”
Tip-ring-sleeve
Phone
Plug
-
1-1.
Balanced
Connection
(Input)
3-1.
AUX
Return
Connect
2-conductor
shielded
cable
as
shown
below.
Connect
2-conductor
shielded
cable
as
shown
below.
__
Screw
Sleeve
[COMMON]
Tip
(Left)
iv
g
—~
Washer
;
:
Ring (Right) Sleeve Ring
(Hot)
(Cold)
(Common)
3-2. Input B (Balanced connection)
3-pin XL-type ‘ :
miele one : Connect 2 single-conductor shielded cables as shown
below.
1-2,
Balanced
Connection
(Output)
Sleeve
[COMMON]
Tip
(Hot)
Connect
2-conductor
shielded
cable
as
shown
below.
Tip
Ring (Cold) Sleeve Ring
Vv Ring
A—o Tip
Sleeve
Note: Tip-ring-sleeve phone jack
For unbalanced connection on Input "B’, use a
single conductor shielded cable with a 1/4” mono
plug, as shown in 2.
3-pin XL-type
female connector
3-3. Insertion
For insertion at the patch points, use a Y-cord adaptor,
wired as tip ; return, ring ; send and sleeve ; common
ona 1/4” TRS phone plug.
1-3. Unbalanced connection
When connecting unbalanced equipment to the mixer,
connect follows : Pin 1 - Common, Pin 2 - Hot, Pin 3 -
Common
'
CAUTION:
Ring
(Send)
Do
not
connect
unbalanced
microphones
to
the
i
mixer when using phantom power. Power supply poe
and
microphone
may
be
damaged.
Sleeve
(Common)
;
Tip
(Return)
TRS phone plug
(Hot)
{Cornmon)
Jumper TS phone plug
3-pin
XL-type
(Common)
female
connector
Connect 2 single-conductor shielded cables as shown
below. The other end of the shielded cables must have
appropriate mating plugs or jacks, or be connected to
tch bay.
2. 1/4” Tip-sleeve Phone Plug (Input and Output) Seen
Connect
single-conductor
shielded
cable
as
shown
Sleeve
(COMMON)
_Tip
(RETURN)
below (Tip - Hot, Sleeve - Common). Tip
Sleeve Ring (SEND) Sleeve Ring
Sleeve 4. RCA Pin-plug Input and Output
Connect single-conductor shielded cable as shown
v7 Tip below.
Sleeve
Tip-sleeve phone jack
Common