Other
19
1 Put a straight-slot screwdriver (commercially available) into the battery case.
• Make sure to keep fingers away from the tip of the screwdriver.
• Use a screwdriver that fits into the slit on the battery case. If it is too small, the battery case will not open
properly.
2 Use the screwdriver for leverage, and push the upper cover A upward.
• Be careful not to touch the battery with the screwdriver.
3 Hold the battery B, and remove it.
4 Pull off the battery B and separate it from the battery case by cutting off the wires, one
by one, with scissors.
• Insulate the wire parts of the removed battery with cellophane tape.
• Do not damage or dismantle the battery.
To Next Page
Loading...
