Panasonic RQ-NX60V - Hold Function; Tape Playback Operations; Auto reverse; Radio Reception

HOLD
| ТАРЕ
| RADIO
KAN)
QNA
This function prevents the unit from operat-
ing inadvertently.
ФА key is displayed when the main unit's
hold function is on. The key flashes when
a button is pressed.
eThe function on the main unit and the re-
mote control are independent of each
other.
During hold state
Auto reverse
Untess [2, OFF W] is pressed, the unit plays
3 sides of the tape and then automatically
stops.
Note:
Do not open the cassette compartment
Cover during tape operation.
eYou can use normal position tapes only.
This unit will not able to do full justice to
characteristics of high and metal position
tapes even if they are played back.
Extend the
How to receive an FM broadcast clearly
Set (FM RECEPTION] to [NORMAL].
When the FM reception is impaired, or there
is interference from a powerful station, set it
to (CITY).
headphones cord.
AM:
CR
FM
Lg
MINA
Preset tuning
Frequencies of up to 20 radio stations (10
each for AM and FM) can be stored in the
memory.
B Memory presetting
(Available only from the main unit)
. Tune in the station to be stored.
. Set [MAIN, SUB, HOLD) to [SUB].
. Press and hold one of the memory
buttons ([1], [2], (3), [4], [5}) for about
2 seconds.
Memory
channel
To select a memory channel trom 6 to 10
1. Press (BATT CHECK, +5).
2. Within 10 seconds press and hold one of
the memory buttons for about 2 seconds.
For example (Memory channel 7):
{ВАТТ CHECK, +5] — [2]
B To recall a preset station
(From the main unit)
1. Set [MAIN, SUB, HOLD) to [SUB].
2. Press a memory button.
To select a memory channel from 6 to
10, press [BATT CHECK, +5] and within
10 seconds press a memory button.
Release the memory button within 2
seconds.
(From the remote control)
During reception, press [+] or [-].
Note:
Pressing [ВАТТ CHECK, +5] again while
“+5” displaying erases it.
When using overseas
Allocations need to be changed according to
ihe area.
Every time the following procedure is per-
formed, the allocation setting changes as
follows:
FM 0.2 MHz, AM 10 kHz
(original setting)
FM 0.1 MHz, AM 10 kHz
{
FM 0.05 MHz, AM 9 kHz
B How to adjust the allocation
settings
{Available only from the main unit)
While playing the radio
1. Set [MAIN, SUB, HOLD] to [MAIN].
2. While pressing [ВАТТ CHECK, +5],
press and hold [5, RADIO ON/BAND) for
about 3 seconds.
eThe changed allocation settings (FM and
then AM) are displayed.
Note:
Converting the allocation erases the stations
previously stored in memory.