Panasonic S-22MK2E5B - Cleaning and Operation Mechanism; Cleaning Instructions; Defrosting Operation; DRY Operation Mode

9
Operation Mechanism

Heating performance

This air conditioner utilizes outside air for heating; its
heating performance reduces as outside temperature
decreases.
→ In the event that heating is not sufcient, please use an
additional heating appliance.

Defrosting

This appliance may start defrosting operation to melt
frost formed in the outdoor unit.


Defrosting starts
: The indoor unit fan stops (or the
speed becomes extremely slow).
→ “
” (STANDBY) appears.


Heating operation resumes after several
minutes
: The indoor unit fan remains stopped (or
it will run at a very slow speed) until the indoor heat
exchanger coil warms up sufciently.
→ “
” (STANDBY) appears.

Defrosting is complete
: The indoor unit fan starts
operation.
→ “
” (STANDBY) disappears.

‘‘DRY’’ operation

Once the room temperature reaches the level that was
set, the outdoor unit repeats the cycle of turning on and
off automatically.

When the room temperature is more likely to reach the
level that was set, the fan speed is set to ‘‘breeze’’ (light
wind) automatically.

Should power failure occur while the unit is
running
The unit will resume operation automatically. Operation
settings prior to power failure will be used.

Cleaning
Cleaning instructions :
• Do not use benzene, thinner or scouring powder.
• Use only soap (
pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
Indoor unit :
Wipe with a soft cloth.
(If it is very dirty, use a cloth moistened with
water.)
Airlters:
• Air lters cleaning is needed every two weeks.
• Wash/rinse the lters gently with water to avoid damage to
the lter surface.
• Dry the lters thoroughly under the shade, away from re
or direct sunlight.
• Replace any damage lter.
NOTE
• Clean the lter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.

After Cleaning
1. After the air lter is cleaned, reinstall it in its original
position.
Be sure to reinstall in reverse order.
2. [In the case of Timer Remote Controller]
Press the Filter reset button.
The
(Filter) indicator on the display goes out.
[In the case of High-spec Wired Remote Controller]
Refer to the Operating Instructions attached to the
optional High-spec Wired Remote Controller.
01_330447_EN.indb 9 2021/3/10 10:32:55