Panasonic S-22MZ1H4A - General; Tools Required for Installation (Not Supplied); Accessories Supplied with Unit; Type of Copper Tube and Insulation Material

5
ENGLISH
1. GENERAL
This booklet briefly outlines where and how to install the
air conditioning system. Please read over the entire set of
instructions for the indoor and outdoor units and make sure all
accessory parts listed are with the system before beginning.
1-1. Tools Required for Installation (not supplied)
1. Flathead screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Carpenter’s level
6. Sabre saw or keyhole saw
7. Hacksaw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)
1-2. Accessories Supplied with Unit
See Table 1-1.
Table Type
1-1 Slim Type Ducted
1-3. Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from a local
source, you will need:
1. Deoxidized annealed copper tube for refrigerant tubing.
2. Foamed polyethylene insulation for copper tubes as
required to precise length of tubing. Wall thickness of the
insulation should be not less than 8 mm.
3. Use insulated copper wire for field wiring. Wire size varies
with the total length of wiring. Refer to 4. ELECTRICAL
WIRING for details.
Check local electrical codes and regulations before
obtaining wire. Also, check any specified instructions or
limitations.
1-4. Additional Materials Required for Installation
1. Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire (See your
local codes.)
3. Putty
4. Refrigeration tubing lubricant
5. Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
Table 1-1 (Slim Type Ducted)
Part Name Figure Q’ty Remarks
Washer 8
For suspending indoor
unit from ceiling
Band 2
Drain hose 1
Operating
instructions
1 A5-size
Installation
instructions
1 Included this instructions
Short-circuit
connection
1
For high static pressure
(Located on the back of
the electrical component
box lid. )
● Use M10 for suspension bolts.
● Suspension bolts and nuts are field supply.
Pana_indoor_F616337_Eng1.indd 5 2014-3-13 16:50:25