Panasonic S-50PY2E5A - Page 172

1-162
1
Simultaneous (Twin) -Type
1-1. Unit Specifi cations
PEY1
2. Ceiling Type S-60PT2E5A×2 / U-125PEY1E8
INDOOR MODEL S-60PT2E5A×2
PANEL MODEL
OUTDOOR MODEL U-125PEY1E8
Branch pipe MODEL CZ-P155BK1
PERFORMANCE TEST CONDITION ISO5151 / EN14511 / EN12102
POWER SUPPLY
ø, Hz 1ø 50Hz 3ø 50Hz
V 220 230 240 380 400 415 Min Max
C
O
O
L
I
N
G
CAPACITY
kW 12.5 12.5 12.5 3.8 13.5
BTU/h 42700 42700 42700 13000 46100
CURRENT A 0.42×2 0.41×2 0.40×2 6.55 6.20 6.00 - -
INPUT POWER
W 50×2 50×2 50×2 4.050k 4.050k 4.050k - -
TOTAL W - 4.150k 4.150k 4.150k 900 5.160k
ANNUAL CONSUMPTION TOTAL kWh
*
4 - - 2075 - - -
EER/EER CLASS
TOTAL(W/W)
*
5/("A"~"G") - - - 3.01 3.01 / B 3.01 4.22 2.62
Erp
*
6
Pdsign kW - - - - - -
SEER (W/W) - - - - - -
Annual consumption kWh------
Class - - - - - -
POWER FACTOR % - - - 94 94 94 - -
NOISE INDOOR
(H/M/L)
dB-A 38/34/30 -
Power Level dB 56/52/48 -
NOISE OUTDOOR
(H/L)
dB-A 56/-
Power Level dB 73/-
H
E
A
T
I
N
G
CAPACITY
kW 12.5 12.5 12.5 3.4 15.0
BTU/h 42700 42700 42700 11600 51200
CURRENT A 0.42×2 0.41×2 0.40×2 5.10 4.85 4.65 - -
INPUT POWER
W 50×2 50×2 50×2 3.150k 3.150k 3.150k - -
TOTAL W - 3.250k 3.250k 3.250k 730 4.400k
COP/COP CLASS
TOTAL(W/W)
*
5/("A"~"G") - - - 3.85 3.85 / A 3.85 4.66 3.41
Erp
*
6
Pdsign kW - - - - - -
Tbivalen °C - - - - - -
SCOP (W/W) - - - - - -
Annual consumption kWh------
Class - - - - - -
POWER FACTOR % - - - 94 94 94 - -
NOISE INDOOR
(H/M/L)
dB-A 38/34/30 - ⁄ ⁄
Power Level dB 56/52/48 -
NOISE OUTDOOR
(H/L)
dB-A - 56/- ⁄ ⁄
Power Level dB - 73/-
EXTRA LOW TEMP Total CAPACITY(kW)/INPUT POWER(W)/COP -
MAX CURRENT(A)/MAX INPUT POWER(W) 0.42×2/50×2 0.41×2/50×2 0.40×2/50×2 10.0/6.19k 10.0/6.51k 10.0/6.75k ⁄
STARTING CURRENT(A)/COMP OUTPUT(W) - - - 6.55/3.0k 6.20/3.0k 6.00/3.0k⁄
NETWORK IMPEDANCE (ΩMAX.) - -
FM OUTPUT (W) 74 90 ⁄
MOISTURE REMOVAL VOLUME L/h(Pt/h) 7.9 (3.95×2) (16.6) -
External static pressure
Pa -
I/D AIR
FLOW
COOL m
3
/min (ft
3
/min) [20/17/14.5 (706/600/512)]×2
HEAT m
3
/min (ft
3
/min) [20/17/14.5 (706/600/512)]×2
O/D AIR
FLOW
COOL m
3
/min (ft
3
/min) 80 (2825)
HEAT m
3
/min (ft
3
/min) 73 (2578)
REFRIGERANT TYPE, AMOUNT
g
(oz) R410A 3.20k (112.9) /
P
R
O
D
I
M
HEIGHT : H mm(inch) 235 (9-1/4) 996 (39-7/32) /
WIDTH : W mm(inch) 1275 (50-3/16) 940 (37-1/32) /
DEPTH : D mm(inch) 690 (27-5/32) 340 (13-13/32) /
P
A
C
D
I
M
HEIGHT : H mm 360 1136 /
WIDTH : W mm 1340 1055 /
DEPTH : D mm 820 485 /
MASS
(NET) k
g
(lb) 33 (73) 85 (187) /
(GROSS) k
g
(lb) 42 (93) 93 (205) /
LAYERS LIMIT (actually) 9 (10) 2 (3)
Operation
Condition
Cool O.D(DBT) 18°C ~ 32°C -10°C ~ 43°C
Heat O.D(DBT) 16°C ~ 30°C -15°C ~ 24°C
P
I
P
I
N
G
PIPE DIAMETER mm (inch) (Liquid)ø9.52(3/8) (Gas)ø15.88(5/8) (Liquid)ø9.52(3/8) (Gas)ø15.88(5/8)
CONNECT METHOD, STD LENGTH m (ft) fl ared type, 5.0(16.4) fl ared type, 5.0(16.4)
PIPE LENGTH RANGE m (ft) 5 ~ 50 (16.4 ~ 164.0) ~ ~
I/D&O/D HEIGHT DIFFERENCE m (ft) 15 (OD located lower) / 30 (OD located higher) (49.2/98.4)
ADD GAS AMOUNT
g
/m (oz/ft) 50 (0.538)
PIPE LENGTH FOR ADDITIONAL GAS m (ft) 30 (98.4)
*1
:
In case it is necessary to indicate the air fl ow volume in (l/s), the value in (m
3
/min.) shall be multiplied by 16.7 and rounded down the decimal point.
*2
:
If the EUROVENT Certifi ed models can be operated under the “extra-low” temperature condition, -7°C dry bulb and -8°C wet-bulb temperatures with rated voltage
230 V shall be used.
*3
:
Network Impedance shall be applicable for EUROPE and CHINA models.
*4
:
The annual consumption is calculated by multiplying the input power at 230 V (400 V) by an average of 500 hours per year in cooling mode.
*5
:
EER and COP classification is at 230 V (400 V) only in accordance with EU directive 2002/31/EC.
*6
:
SEER and SCOP classification is at 230V(400V) only in accordance with EN-14825. For heating, SCOP indicates the value of only Average heating season,
Other fiche data indicates in an attached sheet.
SM830231-02Single欧州.indb162SM830231-02Single欧州.indb162 2014/09/1913:21:172014/09/1913:21:17