Panasonic S Series - Page 84

Slide 83
Troubleshooting 10 Blinks Failure (TC-P**S60, P**ST60)
APSSSC10 Blinks
No.4No.3No.2No.1
List of boards likely to cause this symptomBlink
Code
Replace the A
board
Yes
Unplug the TV. Measure the resistance
between chassis ground and pin
12(P15V) of connector P6 on P board.
No
Is there a short
circuit?
Replace the
A board
Disconnect connector SC20 on
the SC board and perform the
same resistance test.
Yes
No
Is there a short
circuit?
Replace the
SC board
Disconnect connector SS33 on
the SS board and perform the
same resistance test.
Yes
No
Is there a short
circuit?
Replace the
SS board
Replace the
P board
TC-P**S60
Models
TC-P**ST60
Models
Start Here
TC-P60ST60TC-P60S60
TC-P55ST60TC-P55S60
TC-P50ST60TC-P50S60
-----TC-P42S60
Applies to Models
TC-P65S60 TC-P65ST60