Panasonic S Series - Page 85

Slide 84
Troubleshooting 12 Blinks Failure (TC-P**S60, P**ST60)
Yes
Unplug the TV and remove connector A12 from the A board. Plug in the TV. Note: If the power LED does not
turn on automatically after the TV is plugged in as expected, then press the power switch.
No
Is the TV still
shutting down
with 12 blinks?
Start Here
Disconnect the
speakers/woofer one at a
time to determine which
one is bad.
Replace the A
board
Speaker/
Subwoofer
A12 Blinks
No.4No.3No.2No.1
List of boards likely to cause this symptom.Blink
Code
A12
A
A
P
P
Speakers
Connectors
TC-P55ST60
Note: Make sure the
speakers and subwoofer
wires are not pinched.
TC-P60ST60TC-P60S60
TC-P55ST60TC-P55S60
TC-P50ST60TC-P50S60
-----TC-P42S60
Applies to Models
TC-P65S60 TC-P65ST60