- 31 -
The unit does not work as described in the Owner’s Manual.
≥ Update the unit’s firmware. (l 24)
The mode indicator (amber) keeps blinking twice.
≥ This unit is not connected to the network. Touch any switch, and then
check the network connection. (l 12)
The mode indicator (amber) keeps blinking three times.
≥ The update has been failed. Touch any switch, and then try again.
≥ When using a LAN cable, make sure to connect the LAN cable while the
AC power supply cord (AC mains lead) is disconnected. (l 18)
The mode indicator (amber) keeps blinking fast.
≥ An error has occurred. Disconnect the AC power supply cord (AC mains
lead) and reconnect it. Turn the unit on and try again.
Cannot connect to the network.
≥ This unit’s Wi-Fi security supports WPA2™ only. Your wireless router
must therefore be WPA2™ compatible. For details on the security
supported by your router and how to change the settings, please refer to
the operating instructions or contact your Internet service provider.
≥ If the network is set to be invisible, make the network visible while you
set up the network for this unit or make a wired LAN connection. (l 18)
≥ Make sure that the multicast function on the wireless router is enabled.
≥ Depending on the routers, WPS button may not work. Try other
methods. (l 12)
Firmware updates
Network
To Next Page
Loading...
