Panasonic SC-EH60

Problem
Probable cause(s)
Suggested remedy 1 Paae
While listening to tapes ~|
Sound is low, intermittent,
or poor quality, noisy,
scratchy, or unsteady.
Heads are dirty.
Clean the heads.
105
Dolby noise reduction is set in the wrong
position.
Set it to match the Dolby NR recording mode.
46
The deck does not enter the
recording mode.
The erase-prevention tabs are removed from
the cassette.
Attach tape to cover the space left by removal
of the erase-prevention tabs.
102
While listening to compact discs
The display will not show
the correct indication. Disc
play does not start when
you press the play button.
The disc is loaded upside down.
Reload the disc..
32,40
The disc is dirty.
Wipe the disc with a soft cloth.
102
The disc is scratched.
The disc is badly warped.
Replace the disc with a new one.
The disc is nonstandard.
Replace the disc with a different one.
There is condensation inside the CD changer
or the CD player.
Wait for 60 minutes before using the CD
changer or the CD player.
During one-touch editing
“NO TAPE” appears on the
display.
No tape is loaded into deck 2.
Load a tape.
46
“CHANGE TAPE” appears
on the display.
The protector tab on the tape is broken.
Cover the tab's hole with adhesive tape or use
another tape.
102
“ERROR” appears on the
display.
You tried to record tracks from a program
containing more than one disc.
You cannot record programs if containing
tracks ftom more than one disc. If wanting to
do 80 , set the tape deck to normal recording.
While using the remote control
The system cannot be
operated with the remote
control.
The batteries are installed in the reverse
polarity.
Reinsert the batteries in the correct polarity.
8
The batteries are worn.
Replace the batteries with new batteries.
8
brinadnflre sL'Zm® “"’P®"®"*® ‘® Therefore, should service ever be necessary, be sure to
■ Maintenance of external surfaces
To clean this unit, use a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a
soap-and-water solution or a weak detergent solution.
■ Tape head care
To assure sound quality for recording and playback, be sure to clean
the heads with a cleaning tape (sold separately) after approximately
every 10 hours of use.
Wring the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, or chemically treated
cloths to clean this unit. Such chemicals may damage the finish of
your system.