Panasonic SC-EH60

POWER
When you select "PRESET’
“PRESET" ^
.“PRESET* i_>Liklw) jjic
TUNED
TUMNQ MODE
When you select "MANUAL'
"MANUAL" ^
.“MANUAL" u-Ulil oift
When you select "MANUAL'
"MANUAL" ^
.“MANUAL" Jit
OL
TUNER/BANO
feEHSOl
TUNER/BAND
SC-EH60
When you select "PRESET"
■ K/Saw “PRESET" 1$
.“PRESEr ^Uiil Jit
\_
: UMmning tt rmlh hwnirfm^j fea ‘W
This example in the figure shows how to tune in FM stations.
n Switch on the power.
P3 Press TUNER/BAND to select the desired band.
Each time you press this button, "FM" and "AM" will appear
alternately.
Q Press TUNING MOD^ to select “PRESET” or
“MANUAL”.
Each time you press this button, "MANUAL" and "PRESET"
will appear alternately.
♦ Select "PRESET" when stations are preset.
(Refer to "Memory presetting" on pages 26 or 28 to preset
stations.)
•Select "MANUAL" when stations are not preset.
FI Press TUNING (v or a) to tune in the desired
broadcast.
"STEREO" lights when an FM stereo broadcast is being re¬
ceived.
"TUNED" lights when you precisely tune in a broadcast station.
Automatic scanning (when you select “MANUAL” in
step Q);
Press and hold TUNING (v or a ) until the displayed frequency
starts to scroll.
•The scroUing of the displayed frequency will automatically
stop if a broadcast station frequency is located during the
tuning process.
•When there is excessive interference, the automatic scanning
may not function.
To cancel the automatic scanning, press TUNING ( v or a ) once
again.
H Adjust the volume level as you like.
For tuning by remote control (when you select “PRESET”
in step B above):
Specify the channel you want with the numeric buttons (see
page 100).
To select a two-digit channel:
Press >10 and then the two numbers you want within 10 seconds or
so.
Note
When the FM station is preset to "MONO", the "STEREO" indicator
will not light up even if a stereo broadcast is being received.
if noise is excessive In the FM stereo mode Q
Press FM AUTO/MONO.
The sound reception mode switches to "MONO" (monaural) and
"MONO" lights.
The sound will then be heard in monaural. If the broadcast signal is
weak, or if there is a large amount of interference, you will get a
clearer sound using MONO function.
To cancel the "MONO" mode, press the button again.
When “MONO” indicator goes off;
Use this setting for normal listening. Both stereo and monaural
sounds can be heard as they are.
Note
If you change frequencies in the "MONO" mode, the "MONO" mode
will be cancelled.
I-One-touch play B___
When the system is OFF, you can receive the station last tuned
in when you press TUNER/BAND on the remote control.