Panasonic SC-EH60

To cancel program play mode:
Press PROGRAM.
"CLEAR" will appear on the display for approximately 1 second and
all the programmed tracks will be cancelled.
When "FULL” appears:
The number of programmed tracks is limited to 24. No further tracks
can be programmed.
When "—:—” appears:
The total playing time of the programmed tracks has exceeded
99 minutes 59 seconds, or you tried programming track which is
numbered 25 or more. In any case, you can still program and plav
discs.
You can do the following during program play. Q
•Check program contents.
1. PressCANCEL.
"CANCEL" will light.
2. Press or ►► / ► M on the CD player. Every time you
press one of the buttons, the track and program No. are shown
on the display.
3. After the total playing time appears on the display, press
CANCEL. "CANCEL" goes out. r- J.' r'
•Add to the program.
Repeats step Q.
•Cancel entries.
A specific track only:
© Press CANCEL. "CANCEL" will light.
© Press the numeric button(8) of the track you want to cancel, or
press or on the CD player to select the track
you want to cancel and then press CANCEL.
(D Press CANCEL once again. "CANCEL" goes out.
All tracks:
Press PRCXURAM, or press ■ while play is stopped.
For your reference:
•To program the track you are listening to:
If you press PROGRAM during playback, the program mode will
engage and the current playback track will be automatically re¬
corded as program No. 1.
This function allows you to program up to 24 tracks.
n Press CD.
Q Press PROGRAM.
Q Press the numeric button(s) to select the track
you want to play in the desired sequence.
To select a two-digit track:
Press 210 and then the two numbers you want.
El Repeat step Q until you have programmed all
the tracks you want.
H Press P'.
Play will start in the programmed sequence.
Play will stop automatically when all the programmed tracks
have been played.