Panasonic SC-EH60

Chongi0tg the toeei ; ~
Using the internal sound quality
Press PRESET/MANUAL to select the desired mode.
Each time you press PRESET/MANUAL, EQ and SPACE modes will
be switched as follows.
HEAVY-*CLEAR^HALL-^ MANUAL
t___ I
[T] HEAVY : Use to add "punch" to rock and other music.
[ 2 ] CLEAR: Use to clarify the treble range of jazz, etc.
HI HALL: Use to impart a deep bass and spread which will
make you feel as if you were in a large concert hall.
[ 4 ] MANUAL: Refer to the "Finer sound quality changes" section on
page 60.
To cancel the EQ SPACE effect
Press EQ SPACE ON/FLAT to select "FLAT".
Notes
• Recordings cannot be made in the HALL, CLEAR, HEAVY or
MANUAL modes.
•Recording during use of sound quality operation will cause the
"HALL", "CLEAR". "HEAVY" and "MANUAL" indicators to dis¬
appear and light again when recording is completed.
Using the acoustic image EQ
This function allows easy creation of sounds closer to what you
imagine. ^
The figure shows an example where the sound quality has been
adjusted to HEAVY level 2 and SHARP level 3.
|] Press ACOUSTIC IMAGE EQ.
Q Press the AT ^ buttons to move the cursor
to the desired music image.
HEAVY ( A ): When a heavier sound is desired
LIGHT (?): When a lighter sound is desired
SOFT ( ◄ ): When a softer sound is desired
SHARP ( ► ): When a sharper sound is desired
To cancel the ACOUSTIC IMAGE EQ effect
Press EQ SPACE ON/FLAT to select "FLAT".
Notes
•Sounds can be made to fit a total of 36 images.
• The resulting adjustment is automatically stored in memory. When
the ACOUSTIC IMAGE EQ is pressed again, the image last selected
IS automatically selected.