Panasonic SC-EH60

Preparation;
Advance the tape to a point from where recording can start im¬
mediately.
n Switch on the power.
Q Press ^ OPEN on deck 2, and then insert the
tape with the exposed part of the tape facing
downward.
Close the holder.
To record in Dolby B NR:
Press DOLBY NR and check “00 NR” is dis-
piayed.
FI Press REV MODE to seiect the reverse mode.
One side will record, and then the tape will stop automat¬
ically at the tape end.
Both sides will record (forward side^reverse side), and
then the tape will stop automatically at the tape end.
Same as above (Wheif you press • REC PAUSE, "c^D"
will be automatically switched over to
H Tune in the desired station.
See page 30.
n Press # REC PAUSE to put the cassette deck
into the recording standby mode.
REC PAUSE indicator will light.
The playback indicators < or > will start flashing.
F3 P>'ess < or > to start recording.
>: To begin recording from the forward side.
<: To begin recording from the reverse side.
To stop recording:
Press ■ .
To display the tape counter while recording:
Press COUNTER DISPLAY.
The tape counter will be displayed for approximately 5 seconds. This
is a useful way for knowing what point of the tape you're at.
To cut an unnecessary part while recording:
1. Press •REC PAUSE.
The cassette deck will go into the recording standby state,
2. To resume recording, press < or >, whichever playback indicator
is flashing.