Panasonic SC-EH60

One-touch editing
n Press A OPEN on deck 2, and then insert a
tape.
Close the holder.
To record in Dolby B NR.
Press DOLBY NR and check “DD NR” is dis-
piayed.
in Press REV MODE to seiect the reverse mode.
Z: One side will record, and then the tape will stop automat¬
ically at the tape end.
Both sides will record (forward side-^ reverse side), and
then the tape will stop automatically at the tape end.
C^D: Same as above (When you press AI EDIT, "c^D" will be
automatically switched over to
Q Press ^ OPEN/CLOSE to ioad a CD.
Prsss A OPEN/CLOSE again to doss the tray.
Q Press Ai EDiT.
The deck will rewind the tape and recording will start. In the
meantime, "AI EDIT" will scroll across the display from right to
left. However, it will take a moment for recording to actually
begin.
To stop one-touch editing:
Press ■ on the cassette deck.
The CD player also stops.
"EDIT OUT" will scroll across the display from right to left,
When tracks are allotted to side B:
After recording the allotted tracks on side A, the cassette deck will
continue recording on side A and will make a blank portion on side
A in order to measure the proper length of the tape.
To edit-record programmed tracks Q
(3) Perform steps fl-O above, and then press CD and PROGRAM
on the remote control.
(D Select the track number from the remote control with the numeric
buttons.
(§) Repeal step @ until all desired tracks are programmed (max.
24 tracks).
0 Press AI EDIT. Recording will begin.
After edit-recording has finished:
The tape deck automatically puts recording on standby. In the mean¬
time, if "LINK" is flashed on the display, there is enough space on the
tape that you can continue recording from another CD (see page 84).
If you want to link the tracks, do not press ■ on the CD player.