Panasonic SC-EH60

UMn0 ffw tf i H i
To use each timer mode in conjunction
To go to sleep listening to on FM broadcast
and wake up the next morning listening to a
CD
1. Make a play timer setting for a CD.
2. Tune in the desired band and station, and adjust the volume level.
3. Make a sleep timer setting.
To make a timer recording from a radio
broadcast while sleeping, and wake up the
next morning listening to a tape
1. Make a record timer setting.
2. Make a play timer setting for deck 1, and switch the power to
standby mode. (Select of the reverse modes.)
Be sure to set the record timer to finish before the play timer will
begin.
To go to sleep listening to a CD, and then to
make a timer recording from a radio
broadcast
1. Make a record timer setting.
2. Play a CD, and adjust the volume level.
3. Make a sleep timer setting.
Be sure to set the system to switch to standby mode before the
timer recording will begin.
Timer sequence priority:
Sleep timer, record timer, play timer is the order of priority for the
timer operations. Be sure not to make each timer setting overlap.
The sound processor shows the level of each sound range with the
three types of display described belows.
Press DISP MOOEZ-DEMO momentarily.
The spectrum display will change as follows.
HI Normal display
This display indicates the strength of the sound in each tonal
range.
[ 2 ] Peak-hold display
The peak sound value of each sound range is held on the display
for about one second after occurs.
U] Aurora display
The peak sound value of each sound range is displayed in
inverted form.
For your reference:
The demonstration function starts when DISP MODE/-DEMO is
held down.