10
TQBJ2071
DAB/DAB+
[HC302]
Preparation
Press [RADIO/AUX] to select “DAB+”.
Note:
If you select “DAB+” for the first time, the system will tune
automatically.
Manual tuning
1 Press [PLAY MENU] repeatedly to select
“MANUAL SCAN”.
2 Press [R, T] to select the frequency block and
then press [OK].
If no station is detected, “SCAN FAILED” is shown.
Adjust the antenna and try again.
To tune automatically
1 Press [PLAY MENU] to select “AUTOSCAN” and
then press [OK].
“START?” is shown.
2 Press [OK] to start tuning.
“DAB AUTO SCAN” is shown.
If no station is detected, “SCAN FAILED” is shown.
Do manual tuning.
Note:
Preset frequencies are erased after you do automatic tuning.
Memory presetting
You can preset up to 20 stations.
1 Press [PLAY MENU] repeatedly to select
“TUNE MODE”.
2 Press [R, T] to select “STATION” and then press
[OK].
3 Press [2/3] or [5/6] to tune in to the
station.
4 Press [OK].
5 Press [R, T] to select a preset number and then
press [OK].
Repeat steps 3 to 5 to preset more stations.
The new station replaces any station that occupies the
same preset number.
Note:
You cannot preset a station when the station is not
broadcasting or when you have selected a secondary service.
█
Selecting a preset station
1 Press [PLAY MENU] repeatedly to select
“TUNE MODE”.
2 Press [R, T] to select “PRESET” and then press
[OK].
3 Press [2/3] or [5/6] to select the preset
station.
Secondary service
You can listen to secondary services when “ ” is shown.
1 Press [PLAY MENU] repeatedly to select
“DAB SECONDARY”.
2 Press [R, T] to select the secondary service and
then press [OK].
To cancel, select “PRIMARY”.
Note:
The setting is cancelled when you select other stations.
Viewing available information
You can view the following information on the display
panel:
Press [DISPLAY].
Checking the signal quality
You can check the signal quality when adjusting the
antenna.
1 Press [PLAY MENU] repeatedly to select
“SIGNAL QUALITY”.
2 Press [OK].
The frequency block followed by the reception quality
is shown.
To select other frequency blocks, press [R, T].
3 Press [OK] again to exit.
Automatic clock adjustment
You can set the clock to update automatically.
1 Press [PLAY MENU] repeatedly to select
“AUTO CLOCK ADJ”.
2 Press [R, T] to select “ON ADJUST” and then
press [OK].
To cancel, select “OFF ADJUST”.
Dynamic label Information about the DAB
broadcast
PTY display Programme type
Ensemble label The name of the ensemble
Frequency display The frequency block and
frequency is shown
Time display Current time
Frequency
block
Frequency Reception quality
0 (poor) to 8 (excellent)
SC-HC302.300 EB.EG TQBJ2071 En.fm Page 10 Monday, January 8, 2018 11:27 AM
To Next Page
Loading...
