5
TQBJ2155
Overview of controls
Do the procedures with the remote control. You can also use the buttons on the main unit if they are the same.
A Standby/on switch [`], [1]
Press to turn the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a
small amount of power.
B Select the audio source
On the remote control:
Press the corresponding button to select the source.
[ ]: BLUETOOTH
[USB/CD]: USB CD
[RADIO/AUX]: FM AUX
On the main unit:
Select “BLUETOOTH” as the audio source
To start Bluetooth
®
pairing or disconnect a Bluetooth
device, press and hold the corresponding button.
C Basic playback control
D View the setup menu
E View the content information
F Select or confirm the option
G Open or close the sliding door
H Decrease the brightness of the display panel
To cancel, press the button again.
I Adjust the volume level
J Mute the sound
To cancel, press the button again.
“MUTE” is also canceled when you adjust the volume
or when you turn off the system.
K View the play menu
L Select the sound effects
M AUX IN terminal (~11)
N USB port ( ) (~12)
O Sliding door
P Display panel
Q Remote control sensor
Distance: Within approximately 7 m (23 ft)
Angle: Approximately 20° up and down, 30° left
and right
HC300.PC TQBJ2155 En.fm Page 5 Wednesday, April 4, 2018 8:57 AM
To Next Page
Loading...
