14
RQT9633
When this unit is on the same network as the
compatible device, you can select this unit as the
speakers.
Preparation
≥ Connect this unit to the same network as the
compatible device. (> 12)
≥ Turn on the compatible device.
1 Start iTunes on your Mac/PC or the Music App
on your iOS device.
≥ If the Music App on your iOS device is used,
select the file that is to be played.
2 Select this unit from the AirPlay icon at the
bottom right-hand corner of the display.
{. Check the volume settings before starting the playback.
(When AirPlay is used for the first time, the volume may
be output at the maximum setting.)
≥ If you have not changed the name, this unit will be
displayed as “Panasonic HC57 _ _ _ _ _ _”
*
1, 2
.
3 Start play.
≥ This unit can be set to turn on automatically when this unit is
selected as the output speakers. (> 15)
≥ Playback of other audio sources will stop and AirPlay output
will have priority.
≥ Volume changes on the iOS device or iTunes will be applied
to this unit. (Refer to the iTunes Help for the required settings
in iTunes.)
≥ AirPlay will not work when playing back videos on iTunes.
*1: “ _ ” stands for a digit that is unique to each set.
*2: The name that is displayed for this unit can be changed
from the “Edit STEREO SYSTEM name” settings in
“Method 2”. (> 12)
Others
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for 30 minutes.
To cancel this function
1 Press [SETUP] repeatedly to select
“AUTO OFF” and then press [OK].
2 Press [3, 4] to select “OFF” and then press
[OK].
≥ To turn automatic standby on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.
The brightness of this unit’s display can be
changed.
1 Press [SETUP] repeatedly to select “DIMMER”
and then press [OK].
2 Press [3, 4] to select “ON” and then press
[OK].
To cancel the dimmer, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1 Press [CD] to select “CD”.
2 Press and hold [CD] on the main unit and [3]
on the remote control until the main unit’s
display shows “REMOTE 2”.
3 Press and hold [OK] and [3] on the remote
control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps
above by replacing [3] with [4].
Using AirPlay with this
unit’s speakers
e.g., iTunes 10.5
(Bottom right)
Automatic standby
Display brightness
Changing the main unit and
remote control code
SC-HC57-37~RQT9633.book Page 14 Monday, December 5, 2011 6:39 PM
To Next Page
Loading...
