Panasonic SC-HC39

13
RQT9882
ENGLISH
Others
As a factory default, this unit will turn to standby
mode automatically if there is no sound and it is not
being used for approximately 20 minutes.
To cancel this function
1 Press [SETUP] repeatedly to select
“AUTO OFF”.
2 Press [3, 4] to select “OFF” and then press
[OK].

≥ To turn the function on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.
≥ When connected to a Bluetooth
®
device, the function
does not work.
When “SC-HC39” is selected from a paired
Bluetooth
®
device’s Bluetooth
®
menu, this unit will
turn on automatically from standby mode and
establish a Bluetooth
®
connection.
1 Press [SETUP] repeatedly to select
“BLUETOOTH STANDBY”.
2 Press [3, 4] to select “ON” and then press
[OK].

≥ To turn the function off, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1 Press [CD] to select “CD”.
2 While pressing and holding [SELECTOR] on
the unit, press and hold [CD] on the remote
control until the unit’s display shows
“REMOTE 2”.
3 Press and hold [OK] and [CD] on the remote
control for at least 4 seconds.

≥ To change the mode back to “REMOTE 1”, press [CD] to
select “CD” and then repeat the step 2 and 3 but replace
[CD] with [ ].
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
∫ Checking the software version
The version of the installed software is displayed.
Press [SETUP] repeatedly to select “SW VER.” and
then press [OK].
≥ Press [OK] to exit.
Auto off function
Bluetooth
®
standby
Changing the unit and remote
control code
Software update
SC-HC39_PPC~RQT9882_mst.book 13 ページ ２０１４年１月３１日 金曜日 午後７時４５分