Fix the safety holder onto the wall bracket.
Drive safety holder screw to secure the safety holder onto
the wall.
4. Hang the unit on the wall.
6
g Fall-preventive measure (Optional)
Removing the unit from the wall
Remove safety holder screw and the safety holder.
Unmount the unit from the wall.
Unscrew fixing screw (2 pieces).
Hold down both the catches and then slide the wall bracket off the unit
(➡ right).
Reattach the stand to the bottom of the unit and secure it with fixing
screw (2 pieces).
Remove the mounting screw (2 pieces) from the wall.
Remove the fall-preventive wire before step if you are using it.•
C
B
A
C
Pen or a blunt object
Catches
C
5. Install the safety holder.
Safety holder
Fixed to
the wall
Safety holder screw
C
C
Metal fitting
Screw
Wire
Wire
Slot for wire
Wall mount instructions (continued)
Attaching the unit to a wall (Optional) (continued)
Slot both screws into this position firmly.
Wall
Wall bracket
Thread a wire (commercially available) through the slot on the
wall bracket before step 4 (➡ above).
Fix the wire to the wall with a screw (commercially available)
after step 5 (➡ left).
Fix the screw to the wire so that a slack of no more than 5 cm is
kept in the upper centre part of the main unit.
•
Hook the unit securely onto the mounting
screws .
Connect the FM/AM antenna before hanging the
main unit on the wall (➡ page 3).
After hanging the unit, release your hand carefully
to confirm the unit sits securely on the wall.
•
•
To Next Page
Loading...
