Panasonic SDR-SW21 - Page 48

94 VQT2A30 95VQT2A30
Problem What to check
[ERROR
OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN
ON AGAIN.] appears
on the LCD monitor.
The unit detected an error. To protect data, eject the
SD card and set the mode dial to [OFF]. The unit
turns off about 1 minute later.
If the same message is displayed repeatedly after
turning the unit back on, the unit needs servicing.
Disconnect the power supply and consult the dealer
from whom you purchased the unit. Do not attempt
to repair the appliance by yourself.
●
●
The PDF file of
the VideoCam
Suite operating
instructions does
not open.
Is Adobe Acrobat Reader 5.0 or later, or Adobe
Reader 7.0 or later installed on the computer?
Adobe Acrobat Reader 5.0 or later, or Adobe Reader
7.0 or later is required to view the PDF file of the
VideoCam Suite operating instructions.
[DISC IS
UNUSABLE.
CHECK DISC.]
appears on the LCD
monitor.
A disc which cannot be used or a disc which cannot
be written on has been inserted into the DVD burner.
Use a new disc.
Problem What to check
A function cannot
be used or selected.
Because of specifications, this unit has functions that
cannot be used simultaneously.
Examples:
Function Condition
Digital zoom
When in still picture recording
mode
●
Fade
When in still picture recording
mode
While the PRE-REC function
is being set
●
●
Colour night view
When in still picture recording
mode
During recording
(Cannot set or cancel)
While the PRE-REC function
is being set
(Cannot set or cancel)
●
●
●
Backlight
compensation
While setting iris or gain
While using Colour night view
●
●
Soft skin mode
(Set and cancel)
During recording
While the PRE-REC function
is being set
●
●
Help mode
Image stabilizer
When in still picture recording
mode
While using Colour night view
●
●
Scene mode
When in auto recording mode
While using Colour night view
●
●
Change of white
balance mode
When using digital zoom
While using Colour night view
●
●
Adjustment of
shutter speed/
iris or gain
When using scene mode
While using Colour night view
●
●
When [INITIAL SET] is executed from the SETUP
menu, all the settings except for [LANGUAGE]
and [CLOCK SET] will be restored to the defaults
established at the time of purchase, and it will then
become possible to select functions. (P.84)
Others
4
Troubleshooting (cont.)