Panasonic SG-5090 - Page 8

SERVICING THE RECORD PLAYER
CARTRIDGE REPLACEMENT
1. Remove the headshell fixing nut by turning it
clockwise and remove headshell from pickup arm.
2. Remove cartridge from headshell by removing the
two screws and disconnecting the lead wires from
cartridge.
3. Using the two nuts attached, mount a new cartridge
onto headshell so that the cartridge is perpen-
dicular to the disc surface.
4. Install headshell to pickup arm.
Note:
Correct stylus position can be obtained by
relocating the cartridge.
fe ~ Screws
©
, Stylus Setting Position
hes
is
FO
| ie)
S)
——-
a
x
r |
io
|
<a
Ye
Nuts
STYLUS REPLACEMENT
1. Lift pickup arm to a position that will make the stylus
accessible.
2. Gently remove worn stylus and replace it with a new
one.
STYLUS PRESSURE ADJUSTMENT
1. Release pickup arm from its seated position. Place
a record on the turntable. Then, balance the
pickup arm by turning in or out the balance weight
until the stylus is leveled to the surface of the record
(as viewed from the turntable unit side).
SG-5090/m)
2. Set the stylus pressure dial to “0”, and since the
specified stylus pressure of the cartridge is 2.0
grams, set the balance weight dial to “2” by turning
the weight counterclockwise (as viewed from the
front panel side).
Tone Arm Ass'y
—-———-Balance Weight
LUBRICATION
The record player has been thoroughly lubricated at the
factory and under normal use should not be required
additional lubrication. When replacing some parts,
however, it may be necessary to lubricate the parts as
specified.
Note:
Do not allow grease to touch motor pulley, pelt and
turntable.
Grease
Grease