Panasonic SL-S120 - Basic Playback Operation; Sequential and Basic Play; Playback Control Functions; Other Play Methods

|
Sequential Play
POWER OFF
Track number imn play
Llasped playing time of each track
Following steps 1-6
In step 4 connect the stereo headphones earphones to the A} jack (Plug in firmty )
*Play stops automatxally when all the tracks have been played
@]f the unit has been connected to the car audio system, adjust the volume texel betwecn 4 and 6 on
the umt then adjust the volume level on the system
To pause play
Press during play
Press during play
POWER OFF
To stop play
Stop mode
Button
' _ Display/reference
l
|
{
(
t
D
t
t
)
Press again to resume play
Total number of tracks
iD 4448
Total playing time
Press dunng stop mode
POWER OFF
To turn off the
unit
Press during play
Skip forward/
backward
(skip function)
Rapid
forward/
(Backward)
backward
(search function)
(Forward)
@During program play these but-
tons are used to skip forward or
back through the programmed se-
quince of tracks
®Durmg random play the skip but-
tons cannot be used to skip back
to tracks that were played previ-
ously an the random se quence
eDurnng program play random
play or 1 track repeat play search
operation 16 limited to the current
track only
Keep depressed during
play
For your reference
“no disi” indication
This indication appears tor about 40 seconds tf
the ® BE button is pressed when no dtse is
loaded 1n the unit or tf the disc 15 not complete-
lv seated
“np fn” indication
This indication appears for about 10 minutes
when the caver is openid (However the indi
cabon does not appear when the unit 1s pow-
ered off )
Auto power off function
if the umt is left in stop or paused status
for approximately 10 minutes, the unit
powers itselt off automatically in order to
prevent the battery from nmng down
Removing discs
After the dist has stopped rotating press the
PUSH button to release the dise (To protect the
dise never open the cover while it 15 playing )
Never insert foreign objects into the unit body
Other Play Methods
The letters such as @ in the various illustrations refer to the descrip-
tions in the “Location of Controls” (see page 2) section
Skip play
The disc plays from the specific track through
to the end then play stops automatically
Preparation Put uni in stop mode
RMAL
@ RESUME b § 1 RANDOM
2 Select the desired track
SKIP = SEARCH
QO («a
Random play
1 NORMAL
@ RESUME 0 @ 1 RANDOM
>
2
©
f
NORMAL
@ RESUME 4 t 1 RANDOM
For your reference
elt is also possible to press the P| button
while the unit ts in stop status to change the
tirst track to be played (All tracks are played
eventually regardless of whxh ts played
trst }
è Program play 1s not possible in the random
mode
Resume play
This function allows you to listen from the be-
gnung to the track where play stopped be-
cause the unit was powered oft (or switched to
stop status} It 1s useful when listening to CDs
inthe car ete NORMAL
@ RESUME ¢ @ 4 RANDOM
«NORMAL
@ AESUME § § i RANDOM
ELLE EDID
For your reference
[f the RESUMF, NORMAL, RANDOM (play
mode selector) slider 19 put in the RESUML
position the all repeat function will be acti
vated automatically as soon as the urut 1s
powered on
elf power ts cut oft near the end of a track
{power off status) playback mav resume
from the beginning of the next track m some
cases
èlf the unit 1s powered off while a disc was
playing and then a new disc ts inserted play
will begin from the middie of the new disc
because the umt semembers the position
where play stopped on the old disc
Program play
Up to 24 tracks can be entercd in the program-
med sequeme
Preparation Put unitin stop mode
NORMAL
@ RESUME 4$ § 1 RANDOM
2 Select the desired track
BAP @ SEARCH
Qo | | >>
ry
ne
3 Register in sequence
(The imdication M and the pro-
grammed sequence appear on the dis
play panel }
MEMORY!
@ ae
4 Repeat steps 2 and 3 to pro-
gram ali the desired tracks
©
oO
@ To program the same track in the
sequence more than once
After stup 3 press MEMORY /RECAI1 the de-
sired number of times
@ Hf" is displayed
No mor tracks may be addid to the sequence
E To confirm the contents of the pro-
grammed sequence
Press MEMORY/RECALL while the disc 1s
playing (The number of the progrimmed
tracks appear on the display panel in se-
quence )
E To delete the entire programmed
sequence
Press E POWER OFF
Repeat function
Press REPEAT while disc ts playing or when
unit 3s 1n stop status
REPEAT
For your reference
If REPEAT 1s pressed dunng program play,
only the tracks in the programmed sequence
are repeated
(The indication ALL 1s not displayed )
The setting 1s switched in the sequence indicat-
ed below each time REPFAT 1s pressed
1-track repeat (1 œ>)
One track 15 repeated
|
All-track repeat (ALL œ>)
All the tracks on the disc are repeated
|
Cancel
Changing the sound
quality
XBS ON
Select this setting to boost the low-range re
sponsi
XBS
ON | OFF
© ci
—_
OFF
Select this setting to turn oft the 5-XBS tunc-
tion
XBS
ON F IOF
© mm -
—
| Note |
This function 1s available except when using
the OUT jack