Panasonic SL-SX270

Other Play Methods
The
letters
such
as
@
in
the
various
illustrations
refer
to
the
descriptions
in
the
“Location
of
Controts”
section
(see
page
2).
Skip play
The disc plays from the specified track through to the end, then
play stops automatically.
Preparation: Put unit in stop mode.
1
2 Select the desired track.
@
oN)
Program play
Up to 24 tracks can be entered in the programmed sequence.
Preparation: Put unit in stop mode.
2 Select the desired track.
ah
3 Register in sequence.
(The indication “M” and the programmed sequence appear
on the display.)
MEMORY/RECALL
” Q
4 Repeat steps 2 and 3 to program all
the desired tracks.
@
m To program the same track in the se-
quence more than once
After step 3, press [MEMORY/RECALL] desired number of
times.
lf“ £” is displayed
No more tracks can be programmed.
To confirm the contents of the program
Press [{MEMORY/RECALL] while the disc is playing. (The
number of the programmed tracks appear on the display in
sequence.)
@ To delete the entire programmed se-
quence
Press [S,OPR OFF].
Random play
1
(F) NORE í RESUME
(Loafjoo |]
waned, | lees
NO
For your reference:
lt is also possible to press {1] while the unit is in stop mode
to change the first track to be played. {All tracks are played
eventually, regardless of which is played first.}
®Program play is not possible in the random mode.
Resume play
This function atlows you to listen from the beginning of the track
where play stopped because the unit was powered off (or
switched to stop status). It is useful when listening to CDs in the
car, etc.
For your reference:
@lf [NOR, RANDOM ,RESUME) is put in the [RESUME] position,
the all-track repeat function will ba activated automatically as
s00n as the unit is powered on.
$f power is cut off near the end of a track (off mode), playback
may resume from the beginning of the next track.
@lf the unit is powered off while a disc was playing and then a
new disc is inserted, play will begin from the middle of the new
disc because the unit remembers the position where play
stopped on the previous disc.
Repeat function
Press during play or stop mode.
ec
The setting is switched in the sequence indicated below
each time { œ> ] is pressed.
1-track repeat (1 œ>)
One track is repeated.
Alttrack repeat (ALL œ>)
All the tracks on the disc are repeated.
Cancel (no indicator is shown)
For your reference:
tf [@5 ] is pressed during program play, only the tracks
in the program are repeated.
(The indication “ALL” is not displayed.)
Changing the sound quality
Press during play or stop mode.
EQ
The setting switches in the sequence indicated below
each time fEQ} is pressed.
$-XBS— TARAIN— Cancel (no indicator is shown)
ts
S-XBS:
Select this setting to boost the low-range response.
TRAIN:
Select this setting to avoid annoying other passengers
with noise from your headphones/earphones while rid-
ing on the train, or to reduce fatigue when listening for a
long period of time.
Anti-Shock Function
The anti-shock function works by reading audio data and storing
it in memory (up to 40 seconds worth). The unit then fills in inter-
tuptions caused by bumps and vibrations with data from the
memory. This unit also incorporates a powerful anti-shock mach-
anism that prevents skipping caused when play speed is
changed by swinging of the unit.
Press during play or stop mode.
©
A.SHOC
The following indicator appears on the display panel.
If you have pressed [A.SHOCK] when the unit is in stop
mode, press [Jl] to start play.
When bumps continue repeatedly
The message “SORRY” appears on the display and
sound is interrupted.
To cancel the anti-shock function
Press [A.SHOCK] again.
The anti-shock setting can be changed during play,
but this may cause a slight interruption in the sound
because the disc's rotation speed changes.
During anti-shock operation, the disc rotates at a high-
er rate than usual to collect extra audio data. This
could result in a slight increase in disc rotation noise.
Listening to sound with the unit con-
nected to an audio system
The anti-shock function uses digital signal compression
technology. It is recommended that the anti-shock func-
tion be canceled if the unit is connected to a home `
audio system.