Panasonic SX-MB100 - Error Messages and CD Care; Understanding Error Messages

Error messages
PLEASE WAIT!
FAILED, TRY AGAIN
ТИНИ
Appears when it takes some time to complete ап
operation.
COMPLETED!
Appears
when
an
operation
has
been
completed.
You have attempted to play a CD in the CD &
NO
DISC
KEYBOARD
mode,
but
no
CD
is
inserted.
During CD play, the instrument was jarred and sound
SORRY! was interrupted.
Appears when the CD tempo was unable to be
detected within a given time, and the instrument
automatically exits the CD tempo detect mode.
ERROR!
Appears
briefly
when
some
other
error
is
detected.
About the CD
COMPACT
DIGITAL AUDIO
Use a CD which has this mark.
* Please do not use a CD with a heart or other
special mark, as doing so may result in damage.
e Do not insert more than one CD at a time.
• Be sure to remove the CD from the tray before
moving or tilting the instrument.
8 To avoid injuring your CD, as well as damag-
ing your instrument, please heed the following
points.
е Do not use a pencil or ball point pen to write on the СО.
e Do not wipe with record cleaner, thinner, benzene or alcohol.
If soiled, use a clean damp cloth to wipe it clean, and polish
it with a soft, dry cloth.
e Do not affix paper or stickers (decals). (Do not use a CD
from which cellophane tape or a glue-backed label has been
peeled off, as the residual glue may result in damage.)
About the ANTI-SKIP SYSTEM
The ANTI-SKIP SYSTEM minimizes any interrup-
tion to the sound due to vibration by using pre-
sampled (up to 10 seconds) performance data.
e The ANTI-SKIP SYSTEM in this instrument is
always active whenever the power is on. (The
function cannot be disabled.)
elf the instrument is subjected to consecutive
shocks, "SORRY" may appear on the display
and the sound interrupted.
Note: The ANTI-SKIP SYSTEM in this instrument
uses digital compression technology.
32
QQTGO0626