Rear panel
(10) LINE OUT 1 (stereo/monaural M6)
Output the sound from the PA100. (The sound from this terminal is not affected by the
MASTER VOLUME setting).
• To output monaural sound, connect to the R/MONO terminal; do not connect anything to
the L terminal in this case.
(11) LINE OUT 2 (stereo RCA pin plug)
Output the sound from the PA100. (The sound from this terminal is not affected by the
MASTER VOLUME setting).
(12) AUX IN 1 (stereo RCA pin plug)
Input stereo sound from external equipment.
(13) INPUT 2, INPUT 3 (stereo/monaural M6)
Input sound from external equipment.
• Use the LOW/HIGH switch to select the gain appropriate for the input source.
• To input monaural sound, connect to the R/MONO terminal; do not connect anything to
the L terminal in this case.
(14) MIDI
IN: The terminal to receive MIDI data
OUT: The terminal to transmit MIDI data
• Use a commercially sold MIDI cable for these connections.
(15) FOOT SW
When a separately sold Foot Switch (SZ-P1) is connected, the VARIATION on/off and
START/STOP can be controlled with your foot.
13 11 10 15 1412
To Next Page
Loading...
