Automaticallysearchesandaddsavailablechannelstothememory.
_1_Select "ANT in" _3_Selecta scanning mode (p.14)
_ SelectCableorAntenna(p.14)
_2_Select "Auto"
Settings are made automatically
® After the scanning is completed, select "Apply".
(see below (_).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Surf mode"(p. 25)
_i_ Select "Edit"
Select the item to be edited
Favorite
Caption Add
f--J j
R
__ Proceed to
next page
Go back to previous page
÷ Caption:
Changes the station identifier
÷ Favorite:
Registers channel to Favorite
List
÷ Add:
Adds or skips channels
_3_Edit
® Caption
ICaption detail I
Select the station identifier Rename(maximum7 charactersavailable)
® Favorite
I Set favorite I Select the number
@Add RETURN
Press OK to select "Yes (add)" or "No (skip)"
@ Move cursor to channel number
_5_Select "Apply"
(_Cselect "Apply"
@ok
To cancel the Edit
Check the signal strength if an interference is found or freezing occurs on a digital image.
• l 8 m /.f-"'\ ® If the signal is weak, check the antenna.
F-_ _. If no problem is found, consult your local dealer.
Q B g
IF4 FJl FJJ or _< / LiPs"chang
e
' channel
? [i/i f,,-,
2:,ok
@ Not available if "Cable" is selected in "ANT in"
Signal intensity (see above).
@Available only for digital antenna channels.
@
m
Q.
tt_
93
Q.
03
£Q
C)
:::3-
93
O0
® If "Lock" (p. 30) is activated and "Program channel" is selected, "Enter password." will be displayed. 33
To Next Page
Loading...
