24
8.10. Remove the SS2-Board
1. Remove the Tuner unit. (See section 8.5.)
2. Disconnect the bridge connector (SS21-SS24) and dis-
connect the flexible cable (SS58).
3. Remove the screws (×2 ) and remove the SS2-Board.
8.11. Remove the SS-Board
1. Remove the Tuner unit. (See section 8.5.)
2. Unlock the cable clampers to free the cable.
3. Disconnect the connectors (SS11 and SS33).
4. Disconnect the flexible cables (SS61 and SS64).
5. Disconnect the bridge connector (SS21-SS24).
6. Remove the screws (×6 ) and remove the SS-Board.
8.12. Remove the Hanger metals and
the One leg bracket
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the One leg bracket fastening screws (×4
each) and the One leg bracket.
3. Remove the Hanger metals (L, R) fastening screws (×2
each) and remove the Hanger metals (L, R).
8.13. Remove the Cabinet mount
metals
1. Remove the One leg bracket. (See section 8.12.)
2. Remove the Cabinet mount metals fastening screws (×7
, ×14 ) and remove the cabinet mount metal top
and the Cabinet mount metal bottom.
To Next Page
Loading...
