Automaticallysearchesandaddsavailablechannelstothememory.
_ Select"ANTin" @Selectascanning mode (p. 18)
,,,,,,_Select Cable or Antenna (p. 17)
Or select "Not used" to skip TV tuning.
Select "Auto program"
-0)select
Settings are made automatically
® After the scanning is completed, select "Apply".
(see below @).
® All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Channel surf mode"(p. 29)
_1_Select "Edit"
Select the item to be edited
Caption Add
¼
R _G _Proceed to
nextpage
Go backto previous page
Changes the station identifier
÷ Favorite:
Registers channel to Favorite
List
÷ Add:
Adds or skips channels
_3_Edit
® Caption
Select or edit the station identifier,
maximum 7 characters available)
® Favorite
select
Set favorite] Select the number
® Add RETURN
Press OK to select "Yes (add)" or "No (skip)"
@ Move cursor to channel number
_5_Select
To cancel the Edit
Check the signal strength if an interference isfound or freezing occurs on a digital image.
mum
_mm
BDD or
m
Signal intensity ® Not available if "Cable" is selected in "ANT in"
(see above).
® Available only for digital antenna channels.
® If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
@
m
D_
m,
D_
O0
d)
m,
©
d)
Ub
39
To Next Page
Loading...
