Panasonic TC-P42XT50

21
8.2.11. Remove the BT connector clamper
1. Unlock the cable clampers and the tapes to free the
cables.
2. Remove the claws (×2 ) and remove the BT cable.
3. Disconnect the connector (K1) and remove the A1-K1
cable.
4. Remove the claws (×2 ) and remove the BT connector
clamper.
8.2.12. Remove the Stand bracket plate
1. Remove the screws (×6 , ×2 ) and remove the
Stand bracket plate.
8.2.13. Remove the M8 nut metals
1. Remove the screw (×1 each) and remove the M8 nut
metals.
8.2.14. Remove the K-Board
1. Remove the screw (×1 ).
2. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
8.2.15. Remove the Cabinet assy from the
Plasma panel section.
1. Place the Cabinet assy on a flat surface of a table
(covered by a soft cloth) and a cushion.
2. Remove the screws (×3 ).