Technical Information
®Aspect Ratio: 4:3
Size I
ilRr ;
(Continued)
Size 2
® The width will be decreased on both sides to
reduce noise.
®Aspect Ratio: FULL/JUST(H-FILL/ZOOM)
See pages 26-27 for more information
® The width will be increased on both sides to
reduce noise.
Do not display a picture in 4:3 mode for an extended period, as this can cause Side Bar
"Image retention" to remain on either or both sides of the display field.
To reduce the risk of such "Image retention", change the brightness of the side 4:3
bars. Screen
See pages 28-29 for more information Display
® The side bar may flash (alternate black/white) depending on the picture. Using
Cinema mode will reduce such flashing (See below).
iiiiiiiiiliiiiiiiiiii
ii.i_ilili_®i_ : ,
-'t,_lodl,,(.I./; 1
Scrolling bar: To prevent "Image retention", scrolls white vertical bar from left to right on a black screen.
® Press any key except the POWER key to return to previous screen.
® You will return to the previous screen if no key operation has been performed for 15 minutes.
See pages 28-29 for more information
[Scrolling bar]
Mark: Applicable input signal for Component (Y, PB, PR) and HDMI
525 (480) / 60i 15.73 59.94 _
750 (720)/60p 45.00 59.94 _
"1_i25 il,080)/60i- 7: 33.75 59,94 _ _...............
1,125 (1,080)/60p 67.43 59.94
1,125(1,080)/24p 26.97 23.98
1,125 (1,080)/24p _ 27.00 , 24,00 i i
® Signals other than those shown above may not be displayed properly.
® The above signals are reformatted for optimal viewing on your display.
48
To Next Page
Loading...
