[]Assembling the pedestal
_ Fix securely with assembly screws '_(A_y(Total 4 screws).
® Tighten screws firmly.
Po,eit
lli _'_'_-(L} Pole
Base
Front
[] Set-up
® Tighten assembly screws ,(B}(total 4 screws) loosely at first,
then tighten them firmly to fix securely.
Bottom view
Rear side
--Hole for pedestal
installation
Pole
I Work on a flat surface ]
® Fix securely with assembly
screws , _ (Total 4 screws).
Accessories
Assembly screws
(4 of each)
size (M5 x 18)
size (M5 x 30)
Poles (2)
® @ or (R_is printed at the
bottom of the poles.
Base (1)
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.
(1} Remove the assembly screws _B}from the TV.
@} Lift the TV from the pedestal.
_3_Remove the assembly screws _A}from the pole.
Do not disassemble or modify the pedestal.
® Otherwise, the TV may fall over and become damaged, and personal injury may result.
( Caution
Do not use any pedestal other than that provided with this TV.
¢_ Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
_ if you use the pedestal when it is physically damaged, personal injury may result. Contact your
nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
_®if sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal
will not be strong enough to support the TV, and it might fall over and become damaged, and personal
injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified
procedure. (above)
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.
9
To Next Page
Loading...
