Slide
63
Fan SOS (11 Blinks)
FAN CONNECTOR
Follow this procedure to test the fans
one at a time. Unplug the fan’s
connector and place a jumper wire
across the 2 none red wires of the
female connector (See the fan
connector image).
Yes
No
Is the fan error
message shown
on the right
displayed on
the screen?
Replace the
fan
Fans Error Message
Jumper
Repeat the same test for all the fans, if the fan error message
is still displayed after testing all the fans, replace the A board.
If the message is no longer displayed, replace the fan
disconnected when this happened.
To Next Page
Loading...
