15
English
2
2
Press the switch and select an RF
warmth level to start the preheating process.
• Each press switches to the next level. (The selected
mode ashes in blue.)
• The ultrasonic probe increases in temperature as
the RF warmth level is increased.
LOW MED HIGH
Memory function
The previously selected RF warmth level is stored in memory
so that the appliance can be used with the same setting.
This memory function will reset when the appliance has
not been used for a long period of time or when the
battery has ran out.
3
3
Apply the conductive gel while the appliance
is preheating.
• We recommend using a conductive gel that helps
transmit RF and ultrasonic energy.
1.
Apply a macadamia nuts size
(approximately 3 g) of gel into your hand.
2. Spread the gel around the areas of
your face that you want to treat with
this appliance as illustrated by the
areas in the gure.
• Spread conductive gel gently on
your face. Do not rub gel into skin.
Daily skin care products can also be used
• Use the conductive gel or skin care products to help
transmit the RF and ultrasonic energy to the skin.
• Use skin care products that will provide a slippery
surface for the appliance.
Skin care products with large amounts of oil can
obstruct the transmission of RF and ultrasonic energy.
Gel, serum, and milky lotion Cream, toner, lotion, and oil
• If friction begins to develop during use, add some more
skin care product to prevent any negative effects on
the skin due to friction.
4
4
Preheating process completes (takes
approximately 1 minute).
The preheating process will nish approximately 1
minute after turning on the power. A tone will be
triggered, and indicators change from ashing to
glowing states to indicate that the appliance is ready.
Glowing Glowing Glowing
LOW MED HIGH
EH-XR10_EU.indb 15 2019/03/14 19:45:09
To Next Page
Loading...
