17
How to move the head in each mode
RF/Ultrasonic mode - Approximately 10 minutes
(5 seconds per each movement shown by arrow in the gure)
Face line
Mouth to
temples
(Approx. 8 min.)
Move the appliance as your cheeks
are gently lifted upward.
(Repeat directions 1 through .)
(A tone will be triggered 2 minutes before
automatic power off.)
Mouth
(Approx. 2 min.)
Move the appliance upward around
your face lines as your mouth is gently
lifted upward.
(Repeat direction through .)
(A tone will be triggered.)
Automatic power off
RF mode - Approximately 2 minutes
(5 seconds per each movement shown by arrow in the gure)
Forehead
(Approx. 2 min.)
Move from the centre of forehead as
indicated by 1 and 2 in the gure
towards temples.
• Press the upper edge of the head
above the eyebrows as indicated by
3, 4, 5, and 6 in the gure. Gently
move the appliance upward.
(Repeat directions 1 through 6.)
(A tone will be triggered.)
Automatic power off
Note
• Gel might turn to be white and harden during use. That
is not a problem.
• If friction begins to develop during use, add some more
conductive gel to prevent any negative effects on the
skin due to friction.
EH-XR10_EU.indb 17 2019/03/14 19:45:10
To Next Page
Loading...
