EasyManua.ls Logo

Panasonic Toughbook CF-71 Series

Panasonic Toughbook CF-71 Series
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Getting Started
5
Input the Product Number written on the “Certificate of Authenticity” located in
the Windows
®
95 book that comes with this computer then press [Next].
Press [Finish].
6
MP
4
After reading the agreement, select [I accept the agreement] or [I don't accept the
agreement], then press [Next].
If [I accept the agreement] is selected, the [Certificate of Authenticity] will
appear. If [I don't accept the agreement] is selected, the Windows setup
will be aborted.
NOTE
Setup Windows 95
5
Turn your computer on
4
Slide the power switch toward the rear of the computer and hold it for approximately
one second until the power indicator turns on before releasing it.
3 Enter your name and your company’s name, then press [Next].
(It is possible to omit the company name item.)
The License Agreement will be displayed.
Select settings for your region, then press [Next].
Select your keyboard layout, then press [Next].
(for U.S.A.: United States 101)
2
1
Moving the cursor ( ) or clicking buttons can be performed with the touch
pad. ( page 14)
NOTE
Power Switch
Read the LIMITED USE LICENSE AGREEMENT ( page 26)
Before removing the seal covering the power switch, please read the LIMITED USE LI-
CENSE AGREEMENT.
CAUTION
After confirming that the power indicator has turned on, do not touch the power
switch until Windows setup has started.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
Power Indicator
6
The power saving function is factory set, so if there is no input from a key, the touch
pad, or the external mouse for two minutes, the power to the LCD is cut (ECO
mode).
The LCD will resume operation when the touch pad or the external mouse is used
or a key is pressed.
The computer may enter the ECO mode while Windows is setting up or even when
an application software is being installed. In this case, because it is conceivable
that a selection dialog box will be shown, for resuming from the ECO mode, do not
press Enter which may trigger a selection, but instead, press a key unrelated to
the direct triggering of a selection, like .
NOTE
Shift

Other manuals for Panasonic Toughbook CF-71 Series

Related product manuals