28
Troubleshooting
12 Restart the computer by pressing
Del and immediately hold down F2 . Release the
key when the Setup Utility starts up.
If the password has been set, enter the Supervisor Pass-
word.
13 Press F9 .
At the confirmation message, select [Yes] and then press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the excep-
tion of the password(s) will return to their default values.)
14 Press F10 .
At the confirmation message, select [Yes] and press
Enter .
15 Perform the setup procedure for Windows by following
the instructions on the screen.
Windows 2000 Page 12
Windows XP Page 13
16 Run the Setup Utility and change the settings where nec-
essary.
Reinstalling Software
10 At the confirmation message, press Y .
The operation of reinstallation for the hard disk starts au-
tomatically. (The operations take about 15 minutes.)
11 After the reinstallation procedure completes, the follow-
ing message will appear on the display.
Remove the recovery CD.
Ctrl + Alt +
Windows(R) 2000 Professional install wizard will start after reboot.
Remove the Product Recovery CD-ROM, then restart the computer by pressing
Ctrl + Alt + Del (Delete).
Windows 2000
Windows(R) XP Professional install wizard will start after reboot.
Remove the Product Recovery CD-ROM, then restart the computer by pressing
Ctrl + Alt + Del (Delete).
Windows XP
<Changing the drive letter>
You can change the drive letter for the CD drive or hard disk
drive by the following steps.
Drive letters can only be changed when two or more parti-
tions have been created on the hard disk drive. The name
of the C: drive cannot be changed.
We recommend that you make these changes before in-
stalling applications.
Windows 2000
1 Select [Start] - [Settings] - [Control Panel] - [Administra-
tive Tools] - [Computer Management].
2 Select [Disk Management] from [Storage].
3 Right click on the partition of the hard disk or the name of
the CD drive and select [Change Drive Letter and Path...].
4 Select [Edit].
5 Select [Assign a drive letter] and select the new drive let-
ter, and then select [OK].
6 At the confirmation message, select [Yes].
Windows XP
1 Select [Start] - [Control Panel] - [Performance and Mainte-
nance] - [Administrative Tools] - [Computer Management].
2 Select [Disk Management] from [Storage].
3 Right click on the partition of the hard disk or the name of
the CD drive and select [Change Drive Letter and Paths...].
4 Select [Change].
5 Select [Assign the following drive letter] and select the
new drive letter, and then select [OK].
6 At the confirmation message, select [Yes].
When the FIRSTAID FD is to be created, follow the steps
in the readme.txt on the disk. ( page 14)
NOTE
Do not cancel the reinstall procedure before it is
completed.
When a message appears instructing you to insert
the next CD, insert the recovery CD showing the
next number in the sequence, and then select [OK].
If the message “The media does not contain the cor-
rect file” appears, select [OK]. A message will ap-
pear instructing you to insert the next CD.
Confirm that the proper recovery CD has been in-
serted by opening the tray of the CD drive and then
close the tray, then select [OK].
CAUTION
To Next Page
Loading...
