2) Set Satellite for the selected LNB.
– Select No Satellite if you do not know the connected satellite.
(Available satellite is searched in Auto Setup.)
– Select User defined to set Test Transponder Frequency manually.
– If you set to Single Cable, additional settings are required. Set
SingleCable Version, User Band, User Band Frequency and PIN
(depending on the Single Cable router you use). For details, read
the manual of the Single Cable router.
Watching > Tuning and editing channels > Selectable satellites
5. Press BACK/RETURN to store.
6. Select Auto Setup and press OK to access.
7. Select Search Mode / Scan Mode and press OK to access.
8. Set the item and press OK to store.
●
Scan Mode
Quick:
Scans the suitable frequency for the selected satellite.
Full:
Scans the whole frequency range.
●
After settings, select Start scan and press OK to search.
9. A confirmation screen is displayed and press OK to start Auto Setup.
(Settings are made automatically.)
●
When the operation is completed, the channel at the lowest position will
be displayed.
= Note =
●
Set Dual Tuner Mode to On to select DVB-S signal for DVB-via-IP server
function. (Only for dual tuner model)
■ DVB-C, DVB-T, Analogue
1. Select Auto Setup and press OK to access.
2. Set DVB-C Auto Setup Settings and press OK to store. (DVB-C)
●
Scan Mode
Quick:
Scans the suitable frequency in your country.
Full:
Scans the whole frequency range.
- 111 -
To Next Page
Loading...
