●
Check the correct input mode is selected.
●
Check the setting of AV (COMPONENT / VIDEO) in Input Selection to
match the signal being output by the external equipment.
Watching > External equipment
●
Is Backlight, Contrast, Brightness or Colour in the Picture Menu set to the
minimum?
Watching > For best picture > Basic settings
●
Check all required cables and connections are firmly in place.
Blurry or distorted image (no sound or low volume)
●
Reset channels.
Watching > Tuning and editing channels > Auto Setup
There may be a short black image
●
A black image is displayed to avoid picture distortion when an input signal
changes.
There may be red, blue, green and black spots on the screen
●
This is a characteristic of liquid crystal panels and is not a problem. The
liquid crystal panel is built with very high precision technology giving you
fine picture details. Occasionally, a few non-active pixels may appear on
the screen as a fixed point of red, green, blue or black. Please note this
does not affect the performance of the panel.
- 323 -
To Next Page
Loading...
