– Select User defined to set Test Transponder Frequency manually.
– If you set to Single Cable, additional settings are required. Set
SingleCable Version, User Band, User Band Frequency and PIN
(depending on the Single Cable router you use). For details, read
the manual of the Single Cable router.
Watching > Tuning and editing channels > Selectable satellites
5. Press BACK/RETURN to store.
6. Select Auto Setup and press OK to access.
7. Select Search Mode / Scan Mode and press OK to access.
8. Set the item and press OK to store.
●
Scan Mode
Quick:
Scans the suitable frequency for the selected satellite.
Full:
Scans the whole frequency range.
●
After settings, select Start scan and press OK to search.
9. A confirmation screen is displayed and press OK to start Auto Setup.
(Settings are made automatically.)
●
When the operation is completed, the channel at the lowest position will
be displayed.
■ DVB-C, DVB-T, Analogue
1. Select Auto Setup and press OK to access.
2. Set DVB-C Auto Setup Settings and press OK to store. (DVB-C)
●
Scan Mode
Quick:
Scans the suitable frequency in your country.
Full:
Scans the whole frequency range.
●
Normally set Frequency, Symbol Rate and Network ID to Auto. If Auto
is not displayed or if necessary, enter each value specified by your
cable provider with Numeric buttons.
●
After settings, select Start scan and press OK to search.
- 96 -
To Next Page
Loading...
