- 44 -
■ Auto Setup using the buttons on the TV
1. Press and hold INPUT/OK/HOLD for MENU button for 3 seconds to display
the menu
2. Set Auto Setup with following control panel buttons
●
Move the cursor / select from a range of options / select the menu item
(up and down only)
●
Access the menu / store settings after adjustments have been made or
options have been set with INPUT/OK/HOLD for MENU button.
Manual Tuning
●
Normally use Auto Setup or Update Channel List to retune DVB channels.
●
If tuning has not been done completely or for adjusting the direction of the
aerial, use this function. (DVB)
●
All DVB channels found will be added to Channel List.
■ DVB-C
1. Enter the frequency with numeric buttons
●
Normally set Symbol Rate and Service ID to Auto.
2. Select Start scan with
/ and press OK to search
■ DVB-T
1. Select a channel with / and adjust frequency with / for each
channel
●
Set where the level of Signal Quality becomes the maximum.
2. Press OK to search
■ Analogue
Set Analogue channel manually after Auto Setup.
●
Set Sound System and Colour System, and then perform this function.
Normally set Colour System to Auto.
– SC1: PAL B, G, H / SECAM B, G
– SC2: PAL I
To Next Page
Loading...
