Panasonic TY-ER3D4ME - Registration; First Registration; Registration Again

E
NGLISH
9
Registration

First Registration
Perform the First Registration when the 3D Eyewear is
used for the fi rst time.
1. Turn on the TV to see.
2. Slide the tab from the OFF position to the ON position.
The 3D Eyewear will power on and start registration.
Place the 3D Eyewear within 50 cm from the TV while
registration in progress.
3. The green LED lights on the 3D Eyewear for 3 seconds
when the registration is successfully completed.
After fi rst registration, the 3D Eyewear will reconnect with the
TV automatically when 3D Eyewear is powered on near the
TV in 3D mode.

Registration Again
When connection with registered TV fails, or when using
with another TV,re-register the 3D Eyewear.
1. Turn on the TV to see.
2. Within 50 cm from the TV, hold the tab on the MODE
position for more than 2 seconds.
The registration will start.
3. The green LED lights for 3 seconds when the registration
is successfully completed.
* If the registration failed, the 3D Eyewear will power off.
In this case, power off the TV and perform from step 1.
* Do not connect the charging cable while Registration Again.
* Release the tab when Registration Again starts.
3DE4_E.indb 93DE4_E.indb 9 1/23/2012 2:38:30 PM1/23/2012 2:38:30 PM