Panasonic U-100PEY1E8 - Page 369

1
1-359
Reinstall the removed part to be placed in its original position.
(See the section “2-2. Preparation Before Installation”.)
Then install the accessory supplied side covers (L/R) on both
sides of the indoor unit.
Attach the supplied side plates.
Slide the covers from the front side and attach to the claws
of the latches.
Tighten the screws (supplied).
Side plate
Screw
Attach
Attach the accessory supplied side covers.
Insert the side plates in the direction of the arrow and fix
them with 2 screws once you’ve removed.
Screw (accessory supplied)
Side cover (accessory supplied)
Fig. 1-52
Attach the air-intake grille.
When attaching the air-intake grille, perform the reverse
procedure to removing the grille.
Refer to the section “2-2. Preparation Before Installation”.
Be sure to attach the safety string.
Close the air-intake grille and fix the claws of the latches
with the screws.
Safety string
Fig. 1-53
(Ceiling)
Part Name Figure Q’ty Remarks
Special
washer
For temporarily suspending
indoor unit from ceiling
Drain
insulator
For drain hose joint
Flare
insulator
For gas tube joint
For liquid tube joints
For positioning
installation
Clamper
For flare insulator
and wiring
Full-scale
installation
diagram
Drain hose
For main unit + PVC
pipe joints
Hose band
Side
cover (R)
Side
cover (L)
For drain hose
connection
Screw
Operating
Instructions
Installation
Instructions
4
2
1
1
6
1
1
1
1
1
1
1
2
For side cover (L/R)
(Packed in carton box)
For right side
(Packed in carton box)
For left side
2-7. Final Procedure
The indoor unit should be slightly tilted downward toward
the drain pipe connection side as shown in figure below
so that the wastewater can flow smoothly without being
trapped in the middle. (Fig. 1-51)
Ceiling
Approx. 1°
Approx. 2°
Ceiling
Diagonally right down (front view)
(Ex.: Diagonal-right-backwards)
Diagonally backward (side view)
Fig. 1-51
CAUTION
SM830231-02Single欧州.indb359SM830231-02Single欧州.indb359 2014/09/1913:21:592014/09/1913:21:59