3
If the refrigerant comes in contact
withaame,itproducestoxic
gases.
For safety, be sure to turn the 
air conditioner off and also to 
disconnect the power before 
cleaning or servicing.
Pull off the power plug from  
a receptacle, or switch off  
the breaker, or switch off 
the power disconnecting mean to 
isolate the air conditioner from the 
main power supply in case of 
emergency.
Dispose of according to national 
and/or local legislation.
Thisproductmustnotbemodied
or disassembled under any 
circumstances.
Modiedordisassembledunit
maycausere,electricshockor
injury.
Do not clean inside the indoor and 
outdoor units by users. Engage 
authorized dealer or specialist for 
cleaning.
In case of malfunction of this 
appliance, do not repair by yourself. 
Contact the sales dealer or service 
dealer for a repair and disposal.
Provide a power outlet to be used 
exclusively for each unit, and a
power supply disconnect, Earth 
Leakage Circuit Breaker (ELCB)
or Residual Current Device (RCD) 
for overcurrent protection should
be provided in the exclusive line.
Provide a power outlet 
exclusively for each unit, and full 
disconnection means having a 
contact separation in all poles 
mustbeincorporatedinthexed
wiring in accordance with the 
wiring rules.
To prevent possible hazards  
from insulation failure, the 
unit must be grounded.
WARNING
Donotusemodied 
cord, joint cord, 
extension cord or 
unspeciedcordtoprevent
overheatingandre.
The appliance shall be stored 
in a room without continuously 
operating ignition sources (for 
example:openames,an
operating gas appliance or an 
operating electric heater).
Be aware that refrigerants may 
not contain an odour.
An unventilated area where 
theapplianceusingammable
refrigerants is installed shall be 
so constructed that should any 
refrigerant leak, it will not stagnate 
soastocreateareorexplosion
hazard. 
The appliance shall be stored 
in a well-ventilated area where 
the room size corresponds to 
theroomareaasspeciedfor
operation.
After the unit is installed, never 
failtoasktheinstallerfortheoor
space of the room where the unit 
is installed and the refrigerant 
charge amount.
In case the unit or the room 
divider is changed, never fail to 
consult the sales dealer or service 
dealer.
Do not use means to accelerate 
the defrosting process or to clean, 
other than those recommended 
by the manufacturer.
Do not pierce or burn.
In cases that require mechanical 
ventilation, ventilation openings 
shall be kept clear of obstruction.
OI_00_331027_EN.indb   3 2021/9/1   13:03:18