Editing
Editing still pictures (VDR-D150 only)
81
LSQT1048
¬Rotate the mode dial to select .
1 Press the MENU button, then select [ DELETE] #
[ SELECT] or [ ALL] and press the joystick.
≥ When [ALL] is selected, all files on the SD card except the locked files
will be erased. Proceed to step 4.
2 (Only when [SELECT] is selected in step 1)
Select the file to be deleted, then press the joystick.
The selected file is encircled by a yellow frame.
≥ When the joystick is pressed again, the selected file will be cancelled.
≥ Up to 8 files displayed on a page can be set in succession.
3 (Only when [SELECT] is selected in step 1)
Press the button.
4 When the confirmation message appears, select [YES], then press the
joystick.
(Only when [SELECT] is selected in step 1)
To continue deleting other files
Repeat steps 2-4.
To complete editing
Press the MENU button.
∫ Deleting still picture files recorded on an SD card by other products
A still picture file (other than JPEG) that cannot be played back on this unit may be erased.
≥ In case of [ALL], the deletion may take time if there
are many files on the SD card.
≥ Do not turn off this unit while deleting.
≥ When you delete files, use a battery with sufficient
battery power or use the AC adaptor.
≥ Do not remove the SD card while deleting.
≥ If files conforming to DCF standard are deleted, all
the data related to the files will be deleted.
Deleting multiple files from the thumbnail display
LSQT1048(ENG).book 81 ページ ２００６年２月６日 月曜日 午後２時１３分
To Next Page
Loading...
