Others
104
LSQT1146
The DISC EJECT lever
does not work when the
unit is connected to the
computer.
≥ The DISC EJECT lever does not work after the unit is
connected to the computer.
# Use Windows Explorer to right-click the drive icon and execute
[Eject]. Or use the software’s eject button to eject the disc.
Cannot write to DVD-
RAM.
Cannot format a disc with
the DVD-RAM Driver.
≥ (Windows XP only) Deleting the unit name from the Device
Manager and then connecting the unit and the computer again
can improve this. Follow the steps below. Before proceeding,
be sure to remove the disc from the unit.
1) Select [start] # ([Settings] #) [Control Panel] # ([Performance
and Maintenance] #) [System].
2) Click the [Hardware] tab, then click [Device Manager].
3) Right click [MATSHITA DVD-RAM LMXK1987 USB Device]
displayed at [DVD/CD-ROM drives] and then select [Uninstall].
4) When erasing is complete, reboot the computer. The computer
will automatically recognize the unit again.
When the USB cable is
disconnected, an error
message will appear on
the computer.
≥ To disconnect the USB cable safely, double-click the
icon
in the task tray and follow the instructions on the screen.
Problem Check points
LSQT1146.book 104 ページ ２００６年１２月５日 火曜日 午前１０時４０分
To Next Page
Loading...
